Maintaining and Troubleshooting Your 3D Printer by Charles Bell is
your guide to keeping your 3D printer running through preventive
maintenance, repair, and diagnosing and solving problems in 3D
printing. If you’ve bought or built a 3D printer such as a MakerBot
only to be confounded by jagged edges, corner lift, top layers that
aren’t solid, or any of a myriad of other problems that plague 3D
printer enthusiasts, then here is the book to help you get past all
that and recapture the joy of creative fabrication. The book also
includes valuable tips for builders and those who want to modify their
printers to get the most out of their investment. Good fabrication
begins with calibration. Aligning the print bed to support deposition
of medium in three dimensions is critical. Even off-the-shelf machines
that are pre-built must be aligned and periodically realigned
throughout their life cycle. Maintaining and Troubleshooting Your 3D
Printer helps you achieve and hold proper alignment. Maintaining and
Troubleshooting Your 3D Printer also helps with software and hardware
troubleshooting. You’ll learn to diagnose and solve firmware
calibration problems, filament and feed problems, chassis issues, and
more. Finally there are regular maintenance and enhancements. You’ve
invested significantly in your 3D printer. Protect that investment
using the guidance in this book. Learn to clean and lubricate your
printer, to maintain the chassis, and know when realignment of the
print bed is needed. Learn ways to master your craft and improve the
quality of your prints through such things as post-print finishing and
filament management. Don’t let the challenges of 3D printing stand
in the way of creativity. Maintaining and Troubleshooting Your 3D
Printer by Charles Bell helps you conquer the challenges and get the
most benefit from your expensive investmentin personal fabrication.
Les mer
Produktdetaljer
ISBN
9781430268086
Publisert
2018
Utgiver
Vendor
Apress
Språk
Product language
Engelsk
Format
Product format
Digital bok
Forfatter