Selected peer-reviewed extended articles based on abstracts presented at the 5th International Conference on Machining, Materials and Mechanical Technologies (IC3MT 2024)

Aggregated Book

• Preface
• Chapter 1: Cutting and Drilling Technologies
• Cutting Process of Rolled Ti-6Al-4V in Drilling of Countersunk Hole
• Drilling Characteristics of Plastic Materials with Adaptive Control of Feed Rate
• Multi-Quality Decision Using Preference Selection Index Method in Laser Trepan Cutting of Thin Electrical Steel
• Influence of Axis Configuration in 5-Axis Control Machining Center on Geometric Error of Cubic Machined Surfaces
• Electrochemical Machining of Micro Hole under Magnetic Field Assistance
• Study on Improvement of Machining Accuracy of Corner-R with Square Endmill -Effect of Constant Number of Simultaneous Cutting Edge-
• Chapter 2: Wear Resistance and Fatigue Behavior of Steel
• Fundamental Study on Influence of Residual Stress Distribution on Fatigue Strength in ns Pulsed Laser Peening for Welded High-Strength Steel
• Influence of Heat Treatment on Tool Wear of High-Carbon Steel (C55)
• Improvement of Prediction Reliability of Tool Edge Contour Position in Turning ― Influence of Boundary Wear on Process of Dividing Roughness Curve into Feed Marks in Estimating Roughness Components
• Effect of Cutting Temperature on Material Deformation and Residual Stress after Face Milling
• Chapter 3: Cutting Fluids
• Study on Evaluation of Cutting Fluid Using End Face Cutting in Lathe Machining
• In-Line Concentration Monitoring of Water-Soluble Cutting Fluids Using an Automatic Brix Meter
• Chapter 4: Mechatronics and Automation
• Application of Artificial Neural Network to Control Accuracy Dimension of 3D Resin DLP Products
• A Study on the Simulation and the Experimentation to Improve the Energy Efficiency of Servo-Controlled Hydraulic System
• Lighting Simulation for Visual Inspection System Using Patterned Area Illumination
• Chapter 5: Modeling and Computational Research in Mechanical Engineering
• Determination of Geometrical Parameters to Balance the Pressure Drop of Channels on a Microfluidic Chip
• Swing-up and Stabilizing Control of Inverted Pendulum with Restricted Travel Width and Cart Speed
• Empowering Die Selection in V-Bending: Insights from Decision Tree Algorithms
• A Research on the Simulation of Multi-Stage Single Point Incremental Forming (MSPIF) Process on Stainless Steel Sheet SUS304 by Abacus Software
• Effects of Groove Depth and Sheet Thickness on V-Bending Process Predicted by Finite Element Analysis