Selected peer-reviewed full text papers from the 6th International Conference on Advances in Materials, Mechanical and Manufacturing & 2024 13th International Conference on Engineering and Innovative Materials (AMMM 2024 & ICEIM 2024)

• Preface and Committee
• Chapter 1: Additive Manufacturing
• Optimization of Infill Parameters for Fused Filament Fabrication (FFF) of Polyether Ether Ketone (PEEK) Using Adaptive Neuro-Fuzzy Inference System (ANFIS)
• Peanut Hull as an Alternative Biocomposite for Polylactic Acid Filament in Fused Filament Fabrication 3D Printing
• Effect of Rigid Body Motion in Phase Field Simulation of Sintering during Preheating at the Powder Bed Fusion with Electron Beam Conditions
• Chapter 2: Machines Research and Design
• Development of Small Punch Creep Test Rig, Testing and Validation
• Trial Production of Disk Caster for Thin Bar
• Melt Drag Twin Roll Caster
• Design and Properties Analysis of Coating Removal Actuator by Abrasive Water Jet
• Exhaust Emission Analysis of Spark Ignition Engine with Modification of Exhaust Gas Recirculation (EGR), Air Intake Tank, and Swirl Generator
• Chapter 3: Computational Mechanics
• Turbulent Flow Analysis in an Annular Diffuser Having a Rectangular Twisted Hub
• Dynamic Response of a Tube of Heat Exchanger with an Axial Load
• Numerical Considerations on Design Parameters of Diffuser Vane Slit
• Investigation of Stress and Delamination Behaviors of a Bonded Beam Having Orthotropic Inclusion in Adhesive Layer under Tensile Loading
• Modal Analysis of Flax Fiber Reinforced Composite Bridge Using FEA to Support the Design of the Target Bridge Made of Innovative Material