5th International Conference on Mechanical Engineering and Applied Composite Materials
Produktdetaljer
The 5th International Conference on Mechanical Engineering and Applied Composite Materials (MEACM2022) was held on December 28-29, 2022, in Beijing, China (virtual). The conference program covered invited, oral, and poster presentations from scientists working in similar areas to establish platforms for collaborative research projects in this field. This conference brought together leaders from materials and mechanical engineering to exchange and share their experiences, present research results, explore collaborations and spark new ideas, set up new projects and exploit new technology in these fields.
Selected peer-reviewed extended articles based on abstracts presented at the 2022 5th International Conference on Mechanical Engineering and Applied Composite Materials (MEACM)
Aggregated Book
- Preface
- Chapter 1: Mechanics of Materials and Tribology Research
- Observation of Internal Fatigue Cracks in Repeatedly Induction-Heated S45C Bearing Steel under Rotating Bending Fatigue
- Observation of Microstructures in Carburized-Quenched SCM415 Steel under Rotating Bending Fatigue of 716 MPa
- Friction Coefficient during Five-Phased Start-Stop Tests of PEEK-PTFE Hybrid Radial Ball Bearings Reaching 50 c° under 487N at 600rpm in Air
- Observation of Transition Area Origin Cracks on Fracture Surfaces of Carburized JIS SCM415 Bars
- Influence of Groove Roughness on Crack Initiation of PEEK Thrust Bearing in Water
- Microstructure Observation around Hardness Transition Area of Repeated Induction Heated S45C Shaft
- Effects of Loading Magnitude and Fatigue Crack Growth on Crack Opening-Closing Behavior on Silicon Nitride Ball under Cyclic Compression
- Effect of Load on Surface Roughness of PPS Thrust Bearings under Rolling Contact Fatigue in Water
- Observation of Mode I Crack Growth Behavior in 4.762 mm Diameter-Silicon Nitride Ball under Compressive-Tensile Cyclic Loadings
- Chapter 2: Aluminium Alloy Processing
- Optimization Strategy for Molecular Dynamics Simulations of Nanometric Cutting of Aluminium Alloy Using Molecular Modelling
- Forming Parameters and Optimization of A5052 in SPIF Process
- Deformation Evaluation of A5052 Sheet Metal in SPIF Process
- Chapter 3: Modelling and Monitoring in Machinery
- Dynamic Modeling and Analysis of Rotor-Bearing System with Localized Defect in Rotating Machinery