Microstructure Evolution, Corrosion, Heat and Mass Transfer Processes
Heftet /
2026
/ Engelsk
Produktdetaljer
ISBN
9783036420905
Publisert
2026-03-27
Utgiver
Trans Tech Publications Ltd
Vekt
380 gr
Høyde
240 mm
Bredde
170 mm
Dybde
7 mm
Aldersnivå
P, 06
Språk
Product language
Engelsk
Format
Product format
Heftet
Antall sider
142
This special edition presents recent advances in the analysis of heat and mass transfer phenomena, performance, and structural transformation of engineering materials under complex operating conditions.
Les mer
Special topic volume with invited peer-reviewed papers only
- Preface
- Chapter 1: Numerical Investigation of Heat and Mass Transfer Processes
- Numerical Study of MHD Natural Convection in Partially Heated Cubical Cavity Filled with Hybrid Nanofluid
- Rarefied Gas Flow in a Micro Cavity with an Inner Obstacle Using the Lattice Boltzmann Method
- Validation of Lattice Boltzmann Method in Two and Three Dimensions
- Lattice Boltzmann Simulation for Combined Natural and Forced Convection in a Lid-Driven Square Enclosure with an Inner Heat Sink
- Simulation of Natural Convection in a Triangular Cavity Using the Multi-Relaxation Time Lattice Boltzmann Method: Impact of Heated Chip Position
- Chapter 2: Corrosion and Tribological Properties of Structural Materials
- Corrosion Durability of the Deposited Layer on the Thin-Walled Base of Structural Elements Produced by Laser Radiation
- Investigation of Stress Concentrators in Welds on Stress-Corrosion Cracking of X70 Steel Welded Joints in Near-Neutral pH Solution
- Influence of Chemical Carbon Microheterogeneity on Fatigue Crack Growth Parameters in Railway Wheel Steel
- Improvement of Tribological Properties of Steel by Femtosecond Laser-Inductive Microstructuring
- Wear Behavior of Detonation-Sprayed (Ti,Cr)C-Ni Coatings under Dry and Lubricating Environment
- Chapter 3: Microstructure Evolution in Advanced Materials
- Enhancement of Mechanical Properties in Al0.35CoCrFeNi Complex Concentrated Alloys Through Grain Size Tailoring
- Influence of Growth Rate on the Microstructure and Properties of EuBCO Bulk Superconductors Prepared by Top Seeded Melt Growth Process
- Comparison of Properties of CeO2 Doped ZrO2 Samples Prepared by Conventional Sintering and by SPS
- The Influence of the Final Machining Process on the Change of the Microstructure in the Surface Region of Austenitic Stainless Steels
- Microstructure and Hardness Distribution of Laser Powder Bed Fusion-Produced AISI 2507 Super Duplex Stainless Steel
Les mer
Produktdetaljer
ISBN
9783036420905
Publisert
2026-03-27
Utgiver
Trans Tech Publications Ltd
Vekt
380 gr
Høyde
240 mm
Bredde
170 mm
Dybde
7 mm
Aldersnivå
P, 06
Språk
Product language
Engelsk
Format
Product format
Heftet
Antall sider
142