8th International Conference on Materials Engineering and Nano Sciences and 8th International Conference on Material Engineering and Manufacturing
Produktdetaljer
The publication contains research articles that were represented at the 8th International Conference on Materials Engineering and Nano Sciences (ICMENS 2024) and the 8th International Conference on Material Engineering and Manufacturing (ICMEM 2024), which were held in Kwansei Gakuin University, Osaka, Japan, during March 22-25, 2024. The collected articles reflect the latest engineering solutions and research results in chemical engineering, additive manufacturing and mechanical engineering and will be helpful to specialists in the mentioned production areas.
Selected peer-reviewed full text papers from the 8th International Conference on Materials Engineering and Nano Sciences (ICMENS 2024) and the 8th International Conference on Material Engineering and Manufacturing (ICMEM 2024)
- Preface
- Chapter 1: Chemical Engineering
- Textile Wastewater Treatment Using Activated Graphene-Like Biochar Derived from Onion Peel Biomass
- Modification of the Chitosan Spray Coating on Pineapple Pulp as Adsorbent for Copper Ion Adsorption from Aqueous Solution
- Study of Phase Composition and Microstructure of Porous Alumina Ceramics Derived from Hydrothermal Powders
- Chemical Constituents of Black Galingale Rhizome from Hexane Crude Extract and its Nanoemulsion Preparation
- Effect of Bi2O3, B2O3 and V2O5 Sintering Additives on Phase Composition, Microstructure and Electrical Resistivity of SrAlFe11O19 Ceramics
- Particle Characteristics of Diatomite Activated by Alkaline Solution
- Experimental Evaluation of Rheological Properties of Water-Based Drilling Fluid with Fly Ash Additive
- Chapter 2: Additive Manufacturing
- Polyhydroxybutyrate/Polylactic Acid/Polybutylene Succinate Blend Filaments for 3D Printing Applications
- 3D Printing of Urethane Dimethacrylate with Nanoclay for Enhanced Curing Properties via Stereolithography
- Optimization of Multi-Objective Response of FDM Fabricated PLA Parts with Morphological Investigation on the Effects of 3D Printing Parameters
- Comparison of the Mechanical, Thermal and Structural Properties of Gamma-Irradiated and Conventional SLA 3D Printed Methacrylate-Based Photo-Curable Resin for Biomedical Application
- Chapter 3: Modeling in Mechanical Engineering
- Analysis of Vibration Model to Study the Effect of Defect Sizes and Load on Stiffness, Contact Deformation, and Contact Force Variation in Deep Groove Ball Bearing
- CFD Simulation of a Circulating Fluidized Bed Boiler to Improve Air Distribution for Satisfactory Fluidization
- Extended Finite Element Simulation of Axial Semi Elliptical Surface Crack in Bi-Material Pipe
- Optimization of Helical Gear Plunge Shaving Cutting Parameters for Cutter Life Using Taguchi Method
- Combined Influence of a Liner Deformation and Couple Stresses on the Partial Bearing Aspect Ratios