Selected peer-reviewed extended articles based on abstracts presented at the 11th Spring International Conference on Material Sciences and Technology (MST-S 2022)

Aggregated Book

• Preface
• Chapetr 1: Metallurgical Technologies and Materials Processing
• Enlarged Zn Content Improves Fatigue Crack Propagation Resistance of Two Al-Zn-Mg-Cu Alloys with Multiple Aging Tempers
• Study of Quench Sensitivity and Microstructure Evolution of Al-Mg-Si Alloy Sheets
• Effect of the Inhomogeneity of Material Properties on the Quenching and Pre-Stretching Residual Stress in Aluminum Alloy
• Integrated Design and Manufacturing of Aviation Aluminum Alloy Support Based on SLM Technology
• Impurity Characterization by LA-ICP-MS in Terbium Metal after Solid State Electrotransport Purification
• Effects of Deformation Rate on the Mechanical Properties of an Industrial Al-Zn-Mg-Cu Alloy
• Effect of Fe-Rich Phases on Fracture Toughness of High Strength Al-Zn-Mg-Cu Alloy
• Effect of Cu Content on the Microstructures of As-Cast and Homogenized Al-Cu-Mg-Ag Alloys
• Effect of Zn/Mg Ratio on Microstructure Evolution of Al-Zn-Mg-Cu Alloys during Homogenization
• Second Phase Dissolution Evolution of an As-Cast Al-4.0Cu-1.0Li-0.4Mg-0.3Ag-0.1Zr Alloy during Multiple Homogenization Processes
• Regulate and Control Grain Structure Characteristics and Mechanical Properties Control of Al-Zn-Mg-Cu Alloy
• Study on the Microstructure and Mechanical Properties of Dynamic Recrystallization of Metastable β Titanium Alloy
• Study on Microstructure and Mechanical Properties of Al_0.5TiNbX_0.5 High-Entropy Alloys
• Effect of Pre-Deformation Degree on the Mechanical Properties and Microstructural Evolution of a Novel Al-Cu-Li Alloy
• Metal Injection Molding Using Gas-Assisted Technology for Optimizing Density Uniformity and Part Weight Reduction
• Simulation Research on Cold Extrusion Strengthening and Reaming of 7050 Aluminum Alloy Plate Hole
• Effect of Sr and Ni Addition on Microstructure, Tensile Behavior and Electrical Conductivity of Squeeze Cast Al-6Si-3Cu Al Alloy
• Chapter 2: Polymers and Composites
• Technical Analysis and Overview of Recent Advances in Materials Science of Polymers, Polymer Composites and Polymer Nanocomposites
• Study on Failure Characteristics of Typical Rivet Connections of C/SiC Composites
• Study on Clove Oil Microcapsule with Montmorillonite /Polyurethane Hybrid Wall
• Study on the Properties of Chemical Foaming Injection Molded Polyolefin/Chitosan Composites
• Tensile Strength and Morphological Behavior of Treated Oil Pam Empty Fruit Bunch Particle Reinforced Polymeric Composite
• Surface Improvements on Silver Streak Marks of Injection Molded Moisture Plastics Using Gas Counter Pressure and Plasticizing Optimization
• Effect of Concentration of Electrolyte Solution on the Electrochemical Stability of Ionogel
• Chapter 3: Computational Materials Science
• A Perspective on Metamaterials for the Biomechanics Application: Multi-Material Metamaterial (4M) Structures
• A Material Tolerable State Maximum Probability Timing: The Elements of the Uncertainty Measure Conditional Optimization Doctrine
• Investigation of Terahertz Wave Propagation along Symmetric Coplanar Strpline on Multilayer Dielctric Substrates